|
車銑加工中心刀塔結構的動力學建模
（作者未知） 2010/5/22
摘要: 由于車銑加工中心刀塔結構的復雜性和多結合面性 , 本文將其分解為四個子系統 , 結合面用等效彈簧和等效阻尼代替 , 利用一個柔性結合點可以用二個剛性結合點和一個子結構替換的原理 , 并運用機械阻抗凝聚法和子結構綜合法建立了刀塔結構的動力學模型。
關鍵詞: 加工中心; 刀塔; 結合面; 子結構綜合法
(Dep t1ofMechan - electr onic Engineering, Lanzhou Univ1of Tech1, Lanzhou 730050, China)
Abstract: For the comp lexity and multi p le j oint surface of the knife t ower structure, its structure was divided int o four subsystems, j oint surface was rep laced by the state of combining with the equivalent sp ring and equivalent damp ing, a dynamicsmodelwas set up t o utilize the p rinci p le that one flexibilities j oint - point can be rep laced by a subsystemswhose power of characteristics equivalent the j oint - surface’ s dynamic characteristics combining with t wo rigidity j oint - points, and t o use the law of mechanical i mpedance condensati on and the law of sub - structure comp rehensiveness1
Keywords: Machining center ; Knife t ower ; Joint ; The law of sub - structure comp rehensiveness
......
附件下載：點擊論文下載
|